5-Row Right-Angle Header for Automotive Harness Integration
The 2005020321: This Molex stAK50h header bridges a PCB to a cable harness, with 32 male blade contacts arranged across 5 rows — a density that packs a lot of signal and power into a right-angle footprint, saving board-edge real estate. Rated for 14VDC and carrying a dual current spec of 3A and 13A per circuit, it handles mixed loads typical in automotive electronics — low-current signals alongside moderate power feeds — without needing separate connectors.
Current and Voltage Fit for 14V Automotive Systems
The 14VDC rating lines up with standard automotive battery and alternator rails, so this header is right at home in engine control units, body modules, or infotainment harnesses where the supply sits at 12-14V nominal. The dual current rating — 3A on some circuits, 13A on others — means the connector can carry both sensor-level signals and actuator power through the same shell, simplifying the harness layout.
Through-Hole Right-Angle Mounting and Board Guide
No stock-holding claim — each order is sourced per your quantity.