Board-to-Cable/Wire Header with Latch Hold
The 2080333064: This is a 6-position, single-row header from Molex's CONNTAK50 series, designed for board-to-cable/wire connections. The right-angle SMT orientation places the mating axis parallel to the PCB, saving z-height in compact enclosures. The shrouded 4-wall housing with a latch holder provides positive retention and protects the pins from damage during mating — a practical feature for harness assemblies that see vibration or frequent disconnect. Tin-plated mating contacts (39.4 µin thickness) suit applications with moderate mating cycles — think appliance control boards, automotive interior modules, or industrial sensors where the connector is mated a few dozen times over its life.
The 1.80mm pitch sets the board footprint density; at 6 positions the header occupies roughly 10.8mm of board edge. The 14VAC/DC rating aligns with low-voltage signal and power distribution — common in 12V automotive or 24V industrial logic buses. Current rating is listed as 'varies by wire gauge' — the limiting factor is the terminal and wire, not the header pin. For a typical 22 AWG circuit, expect 2-3 A per contact; confirm with the terminal datasheet for your exact wire size.