The Molex Eurostyle ESE 39543 395433002 is a 2-position, single-level PCB terminal block on a 5.00 mm pitch. It terminates wires via a screw-driven rising cage clamp — the screw pushes a brass clamp plate down onto the conductor, not the wire itself, so the conductor isn't nicked or deformed during tightening. Rated for 15 A at 300 V, it accepts 14 to 22 AWG wire, making it a fit for control panel wiring, power supplies, and industrial signal distribution where a compact 2-way termination point on the PCB is needed.
That's wide enough to route a trace between the two through-hole pins on a standard 1 oz copper board without necking the track — useful when the terminal block sits near the edge of the PCB and the traces have to run past it. The side-entry orientation means the wire enters parallel to the board surface, so the block can be placed flush against an enclosure wall or another tall component without the wire bending radius interfering.