What it is and where it sits in the series
The Molex 464369301 is the single-circuit member of the EXTreme Ten60Power 46436 family — a right-angle press-fit power blade receptacle built for high-current board-side termination. The 60 A current rating is the load-carrying ceiling, and the "Ten60" series name is shorthand for exactly that figure per contact. Gold plating at 30.0 µin (0.76 µm) across the mating interface governs the cycle life at this current level.
High-current power interconnect fit
At 60 A per circuit with a 600VAC/250VDC dual voltage rating, this blade serves as a high-current board-side power connector. Gold plating at 30.0 µin (0.76 µm) is thicker than standard tin plating, supporting extended mating cycle life under load. Press-fit termination eliminates a solder joint as a failure point under high continuous current. The right-angle orientation routes the blade parallel to the board plane — the standard Ten60 power midplane configuration. Board guide and mating guide features on the housing align the blade stack during engagement so the high-current contacts seat without angular offset that could cause localised hot spots.
Where the Ten60 class is used
EXTreme Ten60Power connectors are specified in industrial power distribution and telecom infrastructure equipment where substantial current must cross the PCB boundary without undersized wiring or bus bars. The single-position blade is the building block for multi-way stacked arrays in the same series — the BOM position count drives how many of these are populated into a common board footprint.