What this connector is
The 464369308: Press-fit termination replaces solder for board attachment — the compliant pin seats in plated-through holes and makes contact without a reflow profile, which matters in high-current power sections where thermal cycling stresses solder joints. Mounting is right-angle through-hole. The contact finish is gold-over-nickel at 30.0µin (0.76µm). This thickness supports repeated mating cycles without the resistance creep that thin plating suffers at high current.
Ratings that drive the selection
At 60A per circuit this is a genuine power blade — the current path is sized for bus-bar class distribution, not just board-level signal. The voltage ceiling of 600VAC / 250VDC covers most single-phase and low-voltage DC bus architectures found in industrial drives and power supplies. Operating range is -40°C to 105°C, wide enough for unheated enclosure deployments. The housing is Black and rated UL94 V-0 — suitable for end-product flammability compliance in most industrial and infrastructure markets. Board guide and mating guide features reduce misalignment risk in blind-mate or high-vibration power assemblies — the guide rails take lateral drift out of the engagement path before the blade sockets seat.
Where this class of connector is used
EXTreme Ten60Power is Molex's family for high-current board-to-board and board-to-wire power interconnects in industrial automation, motor drives, and server/infrastructure power rails — anywhere that the 60A per circuit ceiling and the press-fit PCB mount make it a better fit than a standard pin-header (K* industrial power interconnect).
Lifecycle and sourcing posture
The 464369308 carries Active lifecycle status and ROHS3 compliance. Quoted to order against BOM quantity — the part is in production with no stated last-time-buy or NRND flag. No official successor or cross-reference is listed in the ledger. ROHS3 is the relevant compliance flag for most EU and Asia-Pacific industrial end-products; confirm your specific region and product category requires ROHS3 or whether REACH / UL listing documentation is also required before committing.