1.25 mm Pitch, 10 Circuits – Board Footprint and Harness Fit
The 0530471060: The through-hole termination with a 0.091" (2.30 mm) post length provides a solid solder joint for moderate mechanical strain from the cable assembly. The post side is tin-plated (1.00 µm) for reliable solder wetting.
Detent Lock and Shrouded Housing – Vibration and Mis-Mate Protection
In a panel or enclosure subject to vibration — say, a small appliance or automotive interior module — this lock prevents the connector from walking apart over time. The 4-wall shrouded housing protects the male blade contacts from being bent during handling or blind mating. It also guides the receptacle into alignment, reducing the chance of stubbing a pin on the housing edge. The natural colour is typical for unkeyed PicoBlade headers — no colour-coding for polarisation.
In the PicoBlade system, the current capacity depends on the crimp terminal and the wire size used in the mating receptacle. For a 10-circuit header, the practical limit is usually 1 A per contact with 28 AWG wire, but always check the derating curve for your specific wire gauge and ambient temperature. The voltage rating is 125 VAC/DC — suitable for low-voltage signal and power distribution.
We source this part through independent distribution channels.