The Amphenol 95687-130HLF is the 30-circuit dual-row member of the BERGSTIK II series — a 0.100" (2.54mm) pitch board-to-board header with square pin array, push-pull fastening, and through-hole solder termination. The insulation body is black nylon rated UL94 V-0. All 30 positions are loaded with gold-plated phosphor bronze contacts at 30.0 µin (0.76 µm) on the mating surface, carrying 5A per circuit at up to 110V.
What the key ratings mean for your BOM
At 30 positions across two rows, this sits at the upper end of the standard BERGSTIK II lineup — the 0.100" (2.54mm) pitch matches the full series footprint, so board routing density is governed by the same 2.54mm grid. The 5A per-contact current rating is the headline figure for power or higher-current signal paths; the 110V rating is conservative for this pitch class and covers most low-voltage board-to-board power and signal applications in industrial controls and instrumentation. The 30.0 µin (0.76 µm) gold plating on the mating surface is a meaningful upgrade over tin — it supports repeated mating cycles without significant degradation of contact resistance. That depth also resists corrosion better in industrial environments where the header may see intermittent exposure before mating. The push-pull fastening type refers to the engagement method at the connector interface: square pin into the receptacle, with a positive retention that holds the mated pair without a separate locking clip. The header is unshrouded, which means the square pins are exposed — the mating half must be a matching BERGSTIK II or compatible 2.54mm pitch IDC ribbon connector, FFC/FPC receptacle, or board-to-board receptacle that accepts the square pin form factor. Without a shroud, keying is handled at the housing or panel level rather than at the connector face itself.
Sourcing and lifecycle
The 95687-130HLF carries Active lifecycle status. No official successor or cross-reference order code is listed in the available record. The part is quoted to order against BOM quantity — confirm the position count, pitch, and contact finish against your design before committing, and reference the BERGSTIK II series compatibility matrix to ensure the mating half matches the square-pin / push-pull engagement of this header.