The Amphenol FCI 95687-164HLF is the 64-position member of the BERGSTIK II dual-row pin header series, a 0.100" (2.54 mm) pitch board-to-board connector intended for through-hole solder mounting on mid-density PCB applications. With 5 A per contact at 110 V and gold flash contacts at 30.0 µin (0.76 µm) thickness, it sits in the signal-duty range of the BERGSTIK II family — unshrouded, push-pull fastening, and rated UL94 V-0.
What the ratings mean for fit and duty
Pitch and footprint: 0.100" (2.54 mm) with 0.100" row spacing — the standard dual-row header footprint, compatible with matching IDC receptacles, card-edge fingers, and the full BERGSTIK II shroud and housing range. The 64-position count spans a wide body; confirm the board keeps-outs match the 0.820" overall contact length before committing. Current and plating: 5 A per contact with 30.0 µin (0.76 µm) gold flash over phosphor bronze — a signal-level contact rated for occasional mating. The plating thickness supports repeated matings better than tin; for high-cycle applications, check whether the full-gold GXT option in the same series carries a higher durability spec. Voltage: 110 V — appropriate for signal and low-voltage power distribution within enclosed equipment. It is not rated for mains or high-voltage bus work. Termination and mounting: through-hole solder with 0.360" (9.14 mm) post length — standard insertion depth for wave or hand-solder board assembly. The push-pull fastening type means the header sits passively in the PCB holes; board retention is solely from solder fillet and hole grip, not a locking feature.
Sourcing and lifecycle
The 95687-164HLF is listed Active — no EOL notice, no last-time-buy date, no official successor on record. Quoted to order against BOM quantity; confirm the mating half and footprint match before specifying, since BERGSTIK II headers mate with a range of receptacle and housing options and the BOM line must reference the correct pair.