Board-Edge Cable Exit at 1.25mm Pitch
The 10114830-10110LF: This 10-position header from the 10114830 series mates a cable assembly to the board edge with the cable running parallel to the PCB — the right-angle SMT orientation keeps the z-height to 3.40mm above the board surface. The 0.049" (1.25mm) pitch is the tightest in this series, which means the PCB footprint needs careful trace routing between pads — a 2-layer board can handle it if the trace width and spacing stay under 0.15mm. Tin-on-tin mating contacts limit the current to 1A per circuit and the mating cycle life to roughly 50 cycles — fine for internal harnesses that connect once and stay put, not for frequent field disconnect.
Sizing the BOM: 10 Positions vs 8-Position Sibling
If your BOM calls for 8 signals, the 10114830-10108LF saves board space and cost; if you need all 10, this part loads every position — no unpopulated contacts.
This shrouded-4 wall header mates with a cable receptacle using a detent lock — the mating half is a 1.25mm-pitch female housing with crimp terminals (not listed here; confirm the specific Amphenol ICC part for your wire gauge).