BNC Jack Kit for RG-8 Class Coax
The 112603: It's built for Belden 8214, 9913, 9914, and LMR-400 cables — the RG-8 class of low-loss coax used in antenna feeds and base-station runs.
Crimp Termination and Cable Fit
The kit includes the contact and ferrule, so you're not hunting for loose parts. The cable group (Belden 8214, 9913, 9914, LMR-400) all share a similar dielectric diameter and braid coverage, so the crimp die and strip length are consistent across them.
500 Mating Cycles for Field Service
The nickel body finish sheds surface oxidation better than bare brass in outdoor cabinets.
Crimp vs Solder: 112603 vs 112553
The 112553 is the same BNC jack, same cable group, same 50 Ohm / 4 GHz electricals — but with solder shield termination instead of crimp. If your harness shop is set up for crimp (hex dies, calibrated tooling), the 112603 is the faster, more repeatable build. If you're doing a one-off repair with a soldering iron, the 112553 might be simpler. Both are active; no cross-reference needed.
