TNC Bulkhead Receptacle with Extended Insulation for High-Voltage RF Paths
The 122332: The extended insulation feature (polyoxymethylene acetal dielectric) provides additional creepage distance, supporting the 500 V rating — useful in RF circuits where DC bias or high-voltage transients ride on the carrier.
Termination and Mounting — Solder Cup Meets Bulkhead
Termination is solder cup on the center contact and a solder tag for the shield — no crimp tool required, but expect hand-soldering for both signal and ground. The connector mounts in a panel cutout with a rear-side nut and includes a lockwasher to prevent rotation under cable strain. The kit ships with the connector, lockwasher, nut, and solder tag — four pieces total. The threaded fastening (TNC standard) gives a positive mechanical lock that resists vibration better than a bayonet BNC.
How It Compares — TNC vs BNC, and the Crimp Variants
Against the BNC variant 112424 (same manufacturer, same 50 Ohm and 500 V rating), the 122332's TNC thread holds the mating pair under vibration and pushes the frequency ceiling from 4 GHz to 11 GHz — a meaningful jump if you're routing RF above the BNC's practical limit. The 122332 also carries extended insulation, where 112424 does not, so for circuits with DC bias riding on the RF line the 122332 gives more creepage margin. Compared to the TNC crimp siblings 122168 and 122108, the 122332 trades crimp convenience for field-serviceable solder cup and solder tag termination — no crimp die set needed, but a soldering iron and steady hand are required.
