TNC Bulkhead Jack for RG-405 Semi-Rigid — 50 Ohm, DC to 11 GHz
The 122400: The threaded coupling gives a vibration-resistant mate typical of TNC interfaces, and the 500-cycle mating rating supports repeated field connect-disconnect without degrading the gold-plated phosphor bronze center contact. This connector is specifically tooled for RG-405 (.085".086" semi-rigid) cable. The kit includes six pieces: the connector body, one contact, one gasket, one insulator, one lockwasher, and one nut. That covers the full bulkhead install — no need to source the sealing gasket or panel hardware separately. The body is brass with nickel finish, the dielectric is PTFE, and the housing color is silver.
Cable Fit and Termination — Why RG-405 Matters
The 122400 is dimensioned for RG-405 semi-rigid cable, which has a solid copper outer conductor (0.085" or 0.086" OD). This is not a crimp-for-all cable group — the ferrule and center contact dimensions match the semi-rigid jacket and dielectric diameters. Using it with a different cable type will not achieve the 50 Ohm impedance match or the mechanical retention. The shield termination is solder, meaning the installer tins the outer conductor and flows it into the connector body for a permanent RF bond. Compare this to the 122168, which is also a TNC jack but covers RG-58, 141, LMR-195, and other flexible cables. The 122168 uses a crimp shield termination and includes a ferrule instead of a gasket. The 122400's solder-shield approach is specific to semi-rigid assemblies where phase stability and low VSWR are the priority.
