SMA Jack, 50 Ohm, 18 GHz — End Launch or Panel Mount
This is the full 18 GHz version of the SMA interface, not a reduced-frequency variant.
Mounting — Two Options on One Connector
The 132384 supports both board edge end launch and panel mount with a front-side nut. For the end launch, the shield tabs solder directly to the board edge ground plane — the signal pin height must match the trace stack-up to keep the 50 Ohm path clean through the transition. For panel mount, the bulkhead nut and lockwasher secure the connector from the front side, with the solder cup or post terminating the center conductor on the inside.
How It Compares — 132203 vs 132134-11
The 132203 is the same connector but limited to 12.4 GHz — a cost-reduced option if your signal path never needs the full 18 GHz. All three use the same PTFE dielectric and bulkhead mounting hardware. For a BOM that already specifies 18 GHz, the 132384 and 132134-11 are drop-in equivalents on the RF side; the 132203 is not.
The kit format (connector + lockwasher + nut) simplifies the BOM line: one line item covers the RF interconnect and its mounting hardware.
