SMB Snap-On Plug for RG-174 and Similar Coax
The 142194: It uses a snap-on fastening type — push to mate, pull to disconnect — which makes it faster to engage than a threaded SMA but less resistant to vibration. This is a field-assembly kit: the bag includes the connector body, an end cap, a crimp ferrule, and a piece of heat shrink tubing. You supply the cable and the solder. The cable groups listed — RG-174, RG-188, RG-188A, RG-316, LMR-100, and M17/119-RG174 — all share a similar dielectric diameter, so the crimp ferrule and centre contact fit without modification. If your cable is not on that list, check the outer jacket and dielectric dimensions against the connector drawing before ordering.
Electrical and Mechanical Limits
The voltage rating of 335 V is the maximum working voltage at sea level; at altitude or inside a sealed enclosure the breakdown margin drops, so keep the RF power below that peak. The dielectric is PTFE, which holds its impedance up to 165 °C. A proper crimp tool for the ferrule diameter is essential — hand-squeezing with pliers will not give a gas-tight connection.
