N-Type Plug for LMR-240 — What's in the Bag
The Amphenol RF 172385 is an N-Type plug, male pin, terminated for LMR-240 cable. It ships as a four-piece kit: the connector body, an end cap, a ferrule, and an insulator — everything needed to complete one cable assembly. The impedance is 50 Ohms, the frequency ceiling is 6 GHz, and the insertion loss lands at 0.3 dB. That loss figure is the total through the mated pair, not per meter of cable — it tells you the connector interface itself contributes minimal signal drop across the band. The 1500 V rating gives headroom for high-power RF feeds where voltage spikes from lightning or switching transients can exceed the nominal line level.
The centre contact is solder-terminated; the shield is crimped. That hybrid termination is standard for LMR-240 — the solder joint gives a repeatable low-resistance connection on the pin, while the crimp barrel grabs the braid and foil without melting the dielectric. The threaded fastening (N-Type interface) provides a positive mechanical lock — vibration won't back it off, and the mating nut torques to a repeatable value for consistent RF performance. With 500 mating cycles rated, it's built for field-service connections where the cable gets disconnected and reconnected several times over the life of the installation.
Both are N-Type, male pin, 50 Ohm, threaded, active, and gold-plated on the centre contact. The decision axis is the cable group: the 172385 is pre-configured for LMR-240, while the 172142 covers RG-55, 142, 223, and 400. If your BOM calls for LMR-240, the 172385 includes the correct ferrule and insulator for that jacket diameter — the 172142 kit won't crimp properly on the smaller LMR-240 cable.
No official cross-reference or second-source part exists for this exact cable-specific kit, so the 172385 order code is the one to commit to the BOM.
