RP-SMA Jack, Male Pin — 50 Ohm, 6 GHz Bulkhead
The 901-10768: Rated for 50 Ohms nominal impedance and a maximum frequency of 6 GHz, this connector covers Wi-Fi, ISM-band, and sub-6 GHz 5G NR signal paths. The threaded coupling and gold-plated brass body suit it for panel-mount RF interconnects where a secure, weather-resistant mate is needed — think antenna ports on access points, test equipment front panels, or bulkhead feedthroughs in outdoor enclosures.
The 335 V voltage rating is the peak working voltage for the air gap and PTFE dielectric inside the connector — enough for RF power amplifiers and antenna bias feeds, but not a mains-power interconnect. The 500 mating-cycle rating is solid for a connector that sees regular disconnect: test-port duty, field-swapped antennas, or lab harnesses where the cable gets unplugged weekly. Gold-on-beryllium copper centre contact and gold body finish keep contact resistance stable across those cycles without fretting corrosion.
Cable and Termination — 0.81 mm Coax, Solder Centre, Crimp Shield
This jack is designed for 0.81 mm OD coaxial cable. The centre contact is soldered; the shield is crimped through the hex crimp ferrule on the body.