Skip to main content
Amphenol PSMP-MSLD-CSB

Amphenol RF PSMP-MSLD-CSB PSMP Jack, 50 Ohm, 10 GHz

MPN PSMP-MSLD-CSB
Active

Amphenol RF PSMP series, PSMP-MSLD-CSB, jack male pin, 50 Ohm, DC to 10 GHz, 1 port, panel mount bulkhead, snap-on limited detent, white bronze brass body, gold-plated center contact, PTFE dielectric, solder termination.

$11.0300 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Jul 2026

Specifications

PSMP-MSLD-CSB key specifications
ParameterValue
MountingPanel Mount
Connector typeJack, Male Pin
Fastening typeSnap-On
Voltage rating480 V
Frequency - max10 GHz
Mounting featureBulkhead - Rear Side Nut
Operating temperature-65°C~165°C
Body materialBrass
Housing colorSilver
Dielectric materialPolytetrafluoroethylene (PTFE)
Center contact materialBrass
PackageBulk

All specifications

PSMP-MSLD-CSB additional specifications
ParameterValue
FeaturesLimited Detent
Impedance50Ohm
Body finishWhite Bronze
Mating cycles100
Number of ports1
Shield terminationSolder
Contact terminationSolder
Center contact platingGold

Product details

PSMP Bulkhead Jack, 50 Ohm to 10 GHz

The PSMP-MSLD-CSB: It's a panel-mount bulkhead connector — rear-side nut secures it through a chassis cutout, and the snap-on coupling uses a limited detent to give a consistent mating depth stop. The white bronze body finish resists corrosion better than plain nickel, which matters when this connector lives on an outdoor antenna or in a humid cabinet. Gold-plated centre contact on a brass body, PTFE dielectric, solder termination on both shield and centre pin. One port, bulk packaged.

Wide Temperature Range, No Gasket

No gasket or sealing feature is listed on this part; the bulkhead mount relies on the chassis hole and rear nut for mechanical retention, not an environmental seal. If you need IP-rated sealing, this isn't it.

MPN
PSMP-MSLD-CSB