The SFW14S-2STME1LF: 0.039" (1.00 mm) pitch sets the SMD footprint — the narrow spacing keeps board real estate tight but demands precise solder-paste stencil alignment for the 14 contacts. Vertical orientation means the FFC stands upright 5.30 mm above the board — check z-height clearance against the enclosure lid or adjacent components.
ZIF Actuator and Mating Cycle Reality
Zero Insertion Force (ZIF) — the front-flip actuator lifts the contacts so the 0.33 mm-thick FFC slides in without force, then the actuator clamps down. 20 mating cycles is the rated life — the tin-plated contact finish wears faster than gold, so this connector suits a build-once or occasional-service harness, not a frequent-disconnect panel.
1 A per contact at 100 V — the tin plating and 1.00 mm pitch together cap the current; for signal-level loads (sensors, logic, low-power I/O) it is adequate.