What This 6-Position, 1mm Pitch ZIF Connector Does
It uses a zero-insertion-force (ZIF) mechanism with a front-flip actuator, accepting FFC or FPC cables 0.30mm thick. The contacts are tin-plated phosphor bronze, rated for 20 mating cycles — fine for internal harnesses that connect once and stay put, but not for frequent field disconnect. Vertical orientation and SMD termination with kinked pins keep the board footprint compact.
Board Fit and Routing: 1.00mm Pitch, 6 Circuits
At 1.00mm pitch, the SFW6S-2STE1LF fits a standard FPC footprint — the 6 positions route through a narrow board edge, leaving room for other components. The kinked pin termination provides a secure solder joint on the SMD pad, and the ZIF actuator locks the cable without stressing the contacts during insertion. For a 6-circuit signal interconnect (e.g., display ribbon, sensor cable), this is a reliable, low-cost choice.