MCX Snap-On Plug for RG-405 Semi-Rigid Cable
It comes as a two-piece kit: one connector body and one contact. The snap-on coupling gives a quick, positive lock without a threaded nut — common in compact RF modules where panel space is tight. Impedance is 50 Ohms, and the frequency range extends to 6 GHz, covering most ISM-band, GPS, and cellular test applications. The gold-plated beryllium copper body and gold-plated brass centre contact resist corrosion and maintain consistent contact resistance across 500 mating cycles.
The cable group is RG-405 (.085" or.086" diameter semi-rigid) — a common microwave-grade coax with a solid outer conductor. Solder the centre pin to the signal conductor, then solder the shield to the connector body. No crimp tool needed; just a soldering iron and the right heat. The PTFE dielectric in the connector matches the cable's dielectric, keeping the impedance transition clean.
What the 6 GHz and 500 Cycles Mean
Rated to 6 GHz with 50 Ohm impedance and 0.1 dB insertion loss, this plug suits short cable runs in test equipment, wireless infrastructure, or antenna feeds where signal integrity matters up to 6 GHz. The 500-cycle mating life is typical for a snap-on RF connector — fine for field-service and occasional reconnection, but not for daily plug/unplug in a production test fixture. For higher cycle counts, look at a threaded SMA or a push-pull variant. The 225 V voltage rating is adequate for RF signal levels; don't push DC bias above that.
Active lifecycle — no end-of-life notice.
