Skip to main content
Molex 0039306107

Molex 0039306107 Mini-Fit Jr Header, 10 Pos, 4.2mm, Tin

MPN 0039306107
Active

Molex Mini-Fit Jr 5566 series, 0039306107, Board-to-Cable/Wire header, 10 circuits, 2 rows, 4.20mm pitch, vertical through-hole, tin-plated male pins, shrouded 4-wall, locking ramp, board lock, UL94 V-2.

$1.7200 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
RoHSROHS3 Compliant
IncotermsDAP / DDP Available
SeriesMini-Fit Jr 5566
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Aug 2026

Specifications

0039306107 key specifications
ParameterValue
SeriesMini-Fit Jr 5566
TypeMale Pin
MountingThrough Hole
Connector typeHeader
Fastening typeLocking Ramp
Contact materialBrass
Insulation colorNatural
Insulation height0.504\" (12.80mm)
Insulation materialPolyamide (PA66), Nylon 6/6
Material flammability ratingUL94 V-2
StyleBoard to Cable/Wire
PackageTray

All specifications

0039306107 additional specifications
ParameterValue
FeaturesBoard Lock
ShroudingShrouded - 4 Wall
TerminationSolder
ApplicationsGeneral Purpose, Industrial, Telecommunications
Contact shapeSquare
Rows2
Pitch0.165\" (4.20mm)
Positions10
Row spacing - mating0.165\" (4.20mm)
Contact finish - postTin
Contact length - post0.138\" (3.50mm)
Contact finish - matingTin
Contact finish thickness - post100.0µin (2.54µm)
Contact finish thickness - mating100.0µin (2.54µm)

Product details

Board Fit and Retention for Harness Builders

The 0039306107: This 10-position header from the Mini-Fit Jr 5566 series uses a 4.20mm pitch — the same spacing as the receptacle, so the board footprint matches the mating half directly. The 0.165" row spacing mirrors the pitch, keeping the two rows aligned for a clean press-fit into the housing. In a panel where the harness is routed tight to the board edge, that board lock keeps the header from lifting off the pads when the cable gets snagged.

If the connector sees quarterly disconnect in a field-service application, the tin surface will wear to copper after roughly 25–50 cycles, depending on insertion force. For a one-time mate-and-forget assembly, tin is the cost-effective choice. The 100.0µinch thickness on the post means the solder joint wets reliably through the tin layer during wave soldering — no extra flux step needed for a clean fillet.

Mating with the Receptacle 39-01-2105

This header mates directly with the Mini-Fit Jr receptacle housing 39-01-2105 (10 circuits, 2 rows). The 4-wall shroud on the header aligns the pins before the contacts touch, so the terminals don't bend on insertion.

MPN
0039306107