Skip to main content
Log in
Hirose Electric Co Ltd GT5E-1P-DS(71) — RF / Coaxial Connectors
Hirose Electric Co Ltd

Hirose GT5E-1P-DS(71) Coaxial Receptacle, 50 Ohm, 2 GHz

MPNGT5E-1P-DS(71)
Active

Hirose GT5 Series coaxial receptacle, GT5E-1P-DS(71), 1 port, male pin, 50 Ohms, 2 GHz, through-hole right-angle, solder termination, board lock, 30 mating cycles, 250 V.

$2.9800Ref. price · indicative, final on quote
StockIn Stock (18)
Lead timeIn Stock wk
MOQ1 pcs
  • New & original stockTraceable channels only — no mixed lots, no re-taped reels.
  • Factory packaging where availableSealed reels, trays and bags; cut quantities always stated on the quote.
  • Photo-verified countsEvery line counted and photographed before the box closes.
  • PayPal buyer protectionPay by T/T, PayPal or Payoneer — card payments covered end to end.
How we verify every order →

Specifications

GT5E-1P-DS(71) Technical Specifications
ParameterValue
SeriesGT5
MountingThrough Hole, Right Angle
Connector typeReceptacle, Male Pin
Fastening typePush-Pull
Voltage rating250 V
Frequency - max2 GHz
Operating temperature-30°C ~ 105°C
Body materialPolyamide (PA), Nylon
Housing colorNatural
Dielectric materialPolybutylene Terephthalate (PBT)
Center contact materialBrass
PackageTray
FeaturesBoard Lock
Impedance50 Ohms
Mating cycles30
Number of ports1
Contact terminationSolder
Center contact platingTin

Product details

Coaxial receptacle for board-edge RF launch

The Hirose GT5E-1P-DS(71) is a single-port coaxial receptacle from the GT5 series, designed as a through-hole, right-angle PCB mount. It carries a male pin centre contact and is terminated by solder. The connector is specified for a 50 Ohm impedance and a maximum frequency of 2 GHz, placing it in the lower RF band suitable for applications like GPS, ISM-band radios, or baseband clock distribution where controlled impedance is needed but multi-gigabit speeds are not.

Mating cycles and field service

Rated for 30 mating cycles, this connector is intended for semi-permanent or low-disconnect installations. The tin-plated brass centre contact is adequate for the cycle count but will show wear sooner than a gold-plated alternative — expect contact resistance to rise after repeated mate/unmate cycles in a test or calibration setup. For a production harness that mates once and stays, the 30-cycle rating is not a limitation.

Frequently asked questions

Where can I buy GT5E-1P-DS(71) and how do I get a price?

The GT5E-1P-DS(71) is sourced to order against an RFQ through independent distribution. Submit a request for quote (RFQ) with your target quantity; availability and current pricing are confirmed at quote time. No stock-holding claim is made here.

What is the impedance of GT5E-1P-DS(71)?

The GT5E-1P-DS(71) is specified for 50 Ohm impedance, matching the standard for most RF systems including GPS, Wi-Fi, and cellular bands.