75 Ohm Coaxial Plug for 1.5C Cable — Right-Angle Exit
The Hirose PL71-LP-1.5C(40) is a 75 Ohm coaxial plug from the PL71 series, designed for right-angle free-hanging termination onto 1.5C-2V or 1.5C-QEV.CW cable groups. The 75 Ohm impedance targets video and broadcast signal paths — think SDI camera links, CCTV runs, and analog video distribution where the impedance match to the cable and source matters more than RF power handling.
2 GHz Bandwidth and 500-Cycle Snap-On Life
Rated to 2 GHz max frequency. Gold plating on the brass center contact maintains consistent contact resistance over 500 cycles.
Termination Kit: Solder Center, Crimp Shield, Heat Shrink Included
The center contact is solder-terminated — you tin the center conductor and flow solder through the pin window — while the braid is crimped with the included ferrule. The package ships as two pieces: the connector body and a heat shrink sleeve that seals the cable entry against moisture and strain. Nickel-plated brass body, silver-colored housing.
Cable Group Fit — Getting the Crimp Right
This plug is dimensioned for cable groups 1.5C-2V and 1.5C-QEV.CW — the common 75 Ohm coax diameters used in Japanese-spec video equipment and some broadcast installs. Using a different cable diameter means the crimp sleeve will not compress evenly, which risks shield pull-out and impedance mismatch at the termination.
Listed as Active in production.