Skip to main content
TE Connectivity AMP Connectors 6116202-1

TE Connectivity 6116202-1 Modular Jack, 8p8c RJ45, Shielded

MPN 6116202-1
Active

TE Connectivity, 6116202-1, modular jack, 8p8c (RJ45, Ethernet), vertical, shielded, press-fit, through hole, Cat5, gold 50.0µin contacts, tube.

$5.3600 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
RoHSRoHS Compliant
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Aug 2026

Specifications

6116202-1 specifications
ParameterValue
MountingThrough Hole
Connector typeJack
Operating temperature-40°C ~ 85°C
LED colorDoes Not Contain LED
Contact materialPhosphor Bronze
Housing materialThermoplastic
PackageTube
RatingsCat5
FeaturesBoard Guide
ShieldingShielded
OrientationVertical
TerminationPress-Fit
Tab directionUser Selectable
Contact finishGold
Rows1
Number of ports1
Contact finish thickness50.0µin (1.27µm)
Number of positions (Contacts)8p8c (RJ45, Ethernet)

Product details

It terminates via press-fit into a through-hole PCB — no solder required, which makes it a clean fit for backplane or high-reliability assemblies where thermal stress from wave soldering is a concern.

The Cat5 rating means this jack is specified for 100 MHz bandwidth, supporting 100BASE-TX and 1000BASE-T (Gigabit Ethernet) over four twisted pairs. The shielded construction helps maintain the 100 Ohm differential impedance through the connector — critical for return loss and crosstalk margins at 100 MHz. For Power over Ethernet (PoE) applications, the Cat5 rating does not directly specify current capacity, but the press-fit termination and gold contacts are typical for PoE-capable designs; confirm the specific PoE class against the system's current draw per pair.

Press-Fit Termination — Solderless Assembly

The press-fit termination uses compliant pins that cold-weld into the plated through-hole during insertion. This eliminates the solder joint, which means no thermal shock to the housing, no flux residue, and easier rework — a press-fit pin can be pressed out and replaced without desoldering. The trade-off is that the PCB hole diameter and plating thickness must match the press-fit tail geometry; the board guide helps keep the jack square to the board during the press operation.

MPN
6116202-1