JST HL series, B04P-HL-A, Board to Cable/Wire Header, 4 Positions, 2 Rows, 0.156" (3.96 mm) Pitch, Through Hole, Solder, Tin Contacts, 7 A, 300 V.
| Parameter | Value |
|---|---|
| Series | HL |
| Gender | Male Pin |
| Mounting type | Through Hole |
| Connector type | Header |
| Fastening type | Latch Holder |
| Voltage rating | 300V |
| Current rating | 7A |
| Operating temperature | -25°C ~ 90°C |
| Contact material | Brass |
| Insulation color | Natural |
| Insulation material | Polyamide (PA66), Nylon 6/6 |
| Material flammability rating | UL94 V-0 |
| Style | Board to Cable/Wire |
| Package | Bulk |
| Features | Board Guide |
| Shrouding | Shrouded - 4 Wall |
| Termination | Solder |
| Contact shape | Rectangular |
| Rows | 2 |
| Pitch | 0.156\" (3.96mm) |
| Positions | 4 |
| Row spacing - mating | 0.156\" (3.96mm) |
| Contact finish - post | Tin |
| Contact finish - mating | Tin |
The JST B04P-HL-A is a 4-position, dual-row board-to-wire header from the HL series, built for distributing power inside equipment enclosures. At a 0.156" (3.96 mm) pitch, the 7 A per circuit rating means each contact carries enough current for a moderate-power rail — think a PSU output or a motor drive feed, not a signal line.
The B04P-HL-A carries 4 positions loaded across two rows, each row spaced at the same 0.156" (3.96 mm) pitch.
The B04P-HL-A is a 4-position, dual-row header with a 0.156" (3.96 mm) pitch. It mounts through-hole and terminates via solder. All 4 positions are loaded.
No, the B04P-HL-A is listed as RoHS non-compliant. Verify the environmental compliance requirements for your application before ordering.