Single-Blade Power Plug for Press-Fit Backplane Assembly
The Molex 0464379201 is a 1-position plug from the EXTreme Ten60Power 46437 series, carrying a single male power blade rated 60 A per contact. It terminates via press-fit into a through-hole, right-angle PCB mount — no solder, which means no thermal shock to the board and easier rework in a backplane or power-distribution assembly.
60 A per Contact — Bus-Level Current in a Single Blade
The 60 A per contact rating means this single-position plug carries the kind of current you expect on a main DC rail or AC bus bar, not a signal line. The voltage rating splits by current type: 600 VAC and 250 VDC, so the same blade handles line-to-line AC or a lower-voltage DC bus. The single-row layout (1 row, 1 position loaded) keeps the footprint compact — one hole pattern, one press-fit pin, no wasted board space.
Press-Fit Termination — Solderless for High-Reliability Power
Press-fit termination avoids the heat and flux residue of wave soldering, which is why it shows up in backplane and high-reliability power assemblies where every joint is a potential failure point. The right-angle orientation places the blade parallel to the PCB, letting the mating receptacle approach from the board edge — typical for a power inlet that routes cable out of an enclosure.