What this 4-position header connects and where it sits in the CP-6.5 line
It carries 4 positions in 2 rows on a 6.50mm pitch, with a fully shrouded 4-wall housing that protects the male pins during mating and unmating. The 6.50mm pitch is wider than typical signal headers, which suits it for power distribution in industrial and general-purpose equipment where higher current per circuit is needed.
The header mates with a CP-6.5 receptacle housing (cable side) using the latch holder fastening system — the 4-wall shroud guides alignment. Termination is through-hole with kinked pins for solder retention on the board.