The Molex 73171-3230 is a 75 Ohm BNC jack from the 73415 series, designed for through-hole PCB mounting with solder termination. It carries a single female socket port and uses a bayonet lock for quick, secure mating — the standard twist-to-lock coupling that prevents accidental disconnect in panel or board-edge applications. Rated for signals up to 3 GHz and 500 V, this jack sits in the 75 Ohm branch of BNC connectors, the impedance used for composite video, CCTV, and broadcast RF paths rather than the 50 Ohm data-comm standard.
The 75 Ohm impedance is the first check — if your system is built around 50 Ohm BNC (common for RF test equipment, cellular, or GPS), this jack will introduce a mismatch that degrades return loss. At 3 GHz, the 75 Ohm path supports HD-SDI video at 3G rates and high-resolution analog video without rolling off the signal. The 500 V rating is generous for a BNC of this class — typical video signals run under 5 V, so the voltage ceiling is not the limiting factor; the impedance and frequency bandwidth are what govern the signal path. Through-hole mounting gives a mechanically robust solder joint that handles the torque of repeated bayonet mating cycles better than an SMT footprint would.
Shield termination is also solder, meaning the outer braid of the coax is soldered to the shield tabs for a continuous ground path. The bayonet lock mates with any standard 75 Ohm BNC plug; no special keying or polarisation beyond the BNC bayonet pattern.
