13-Pin Breakaway Header, 0.100" Pitch — AMPMODU Mod II
The 1-104344-1: The unshrouded design with push-pull fastening allows easy breakaway for prototyping or low-vibration environments. The through-hole termination with kinked pins provides mechanical retention during soldering and resists shear from cable strain.
Obsolete — Sourced Through Independent Channels
The 1-104344-1 carries an Obsolete lifecycle status from TE Connectivity. No official successor or pin-compatible replacement is recorded from the original manufacturer. Available through independent surplus channels; quantities are lot-specific and confirmed at RFQ. For new designs, consider the active AMPMODU Mod II headers with matching pitch and circuit count — verify the BOM position and mating half before committing.
This header mates with AMPMODU Mod II receptacles or IDC sockets of the same pitch and circuit count. The male square pins (0.025" square typical) accept crimp-socket or insulation-displacement contacts. The kinked solder pins (0.120" post length) fit standard 0.100" grid through-hole PCBs. The insulation height of 0.090" (2.29 mm) clears most board-mounted components.
Environmental and Compliance Ratings
Contact material is copper alloy with tin-lead post finish (100 µinch) for solderability. The 30 VAC voltage rating is suitable for signal-level circuits; derate current above 25°C per the AMPMODU derating curve.