Crimp pin for Multimate III+ housings
It's the male half that goes into the standard Multimate III+ pin cavity — mates with any receptacle housing in that series. The tin-plated brass construction (50.0µin finish) handles moderate mating cycles in dry indoor equipment; it's not built for frequent disconnect or wet environments. For a sealed or high-vibration harness, you'd step up to a gold-plated contact in the same series.
Wiring and tooling
Crimp this pin with the standard Multimate III+ tooling — the barrel accepts 14-18 AWG stranded or solid wire. The stamped body gives a consistent crimp profile across the full wire range. No special die change needed between 14 and 18 AWG; the crimp height adjusts on the tool. Once seated in the housing, the contact locks with the series' standard retention tines.