Stamped Pin Contact for Mini-Universal MATE-N-LOK Housings
This is the loose-piece pin that gets crimped onto a wire and inserted into the matching receptacle housing — it is not a pre-loaded header or a complete connector assembly. The crimp termination accepts 22-26 AWG wire, which is the standard range for signal-level and moderate-power circuits in this connector family.
Wire Range and Crimp Fit
The 22-26 AWG wire gauge range is the primary fit constraint for a harness builder. A 22 AWG wire carries more current and fills more of the crimp barrel; a 26 AWG wire is finer and requires the crimp tool to be adjusted or the die changed to avoid over-crimping. The stamped construction means the contact barrel has a defined cross-section that matches standard open-barrel crimp tooling for the Mini-Universal MATE-N-LOK series. Confirm the wire insulation diameter fits the rear seal if the housing is a sealed variant.
Mating Housing and System Fit
This pin contact mates with the corresponding receptacle housing in the Mini-Universal MATE-N-LOK series. The housing is a separate order — the 1-770985-0 is only the pin terminal.