6-position IDC socket on 2.00mm pitch — the wire-to-board match for discrete harnesses
IDC termination on discrete wire means the insulation is displaced by the contact tines as the housing is pressed down — no separate crimp terminal or tooling beyond the IDC press. The 20-26 AWG range covers common signal and low-power wire sizes; the wire type must be discrete (not ribbon cable) for the IDC slot geometry to work. A loose wire strand or oversized insulation OD will cause an open or intermittent connection at the IDC interface.
No last-time-buy or end-of-life notice applies to this order code.