The connector is supplied as a three-piece kit: one connector body, one contact, and one ferrule. Rated for RG-142, 142A, and 142B cable — a common semi-rigid coax used in test equipment, aerospace instrumentation, and RF harnesses where the 50 Ohm impedance and 11 GHz bandwidth are needed. Gold plating on the center contact and 500 mating cycles mean this connector is built for repeated field connections in a controlled environment — not a high-cycle production test port, but reliable for installation and periodic disconnect in a lab or rack setup.
The crimp termination requires the matching die set for the RG-142 cable OD and the center contact pin size. The three-piece kit (connector body, contact, ferrule) is the full set needed for one termination; no additional parts are required. The TNC interface is threaded and mates with any standard TNC female jack or bulkhead receptacle.