Skip to main content
TE Connectivity AMP Connectors 228553-1

TE 228553-1 SMB Jack-to-Jack Adapter, 50 Ohm, 4 GHz

MPN 228553-1
Obsolete

TE Connectivity SMB jack-to-jack adapter, 50 Ohm, DC to 4 GHz, brass body with nickel finish, gold-plated brass center contact, PTFE dielectric, bulkhead panel mount, 500 mating cycles, includes lockwasher and nut.

$7.9900 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Jul 2026

Specifications

228553-1 key specifications
ParameterValue
Adapter typeJack to Jack
MountingPanel Mount
Adapter seriesSMB to SMB
Fastening typeSnap-On, Snap-On
Conversion typeSame Series
Frequency - max4 GHz
Mounting featureBulkhead
Body materialBrass
Dielectric materialPolytetrafluoroethylene (PTFE)
Center contact materialBrass
StyleStraight
PackageBulk

All specifications

228553-1 additional specifications
ParameterValue
Includes3 pcs - 1 Connector, 1 Lockwasher, 1 Nut
Impedance50 Ohms
Body finishNickel
Center genderMale to Male
Mating cycles500
Center contact platingGold
Convert to (Adapter end)SMB Jack, Male Pin
Convert from (Adapter end)SMB Jack, Male Pin

Product details

The TE Connectivity 228553-1 is a same-series SMB adapter configured jack to jack, with male pin center contacts on both ends. It converts one SMB jack interface to another SMB jack interface — a straight pass-through for extending or panel-mounting an SMB signal path without changing the connector family. The dielectric is PTFE, a common choice for RF connectors because of its stable dielectric constant and low loss up through several GHz. Mounting is bulkhead panel mount, secured with the included lockwasher and nut. The package ships three pieces: the connector body, the lockwasher, and the nut. No separate hardware order needed for the panel installation.

We source 228553-1 through our network of independent distributors and brokers. Because there is no direct factory replacement, the buyer should verify the adapter's fit against the existing SMB interface and confirm the center pin gender (male to male) matches the mating connectors on both ends.

Mating and Installation Notes

Both ends are SMB jacks with male center pins — snap-on coupling on both sides. The adapter mates with any standard SMB plug (female center contact). The snap-on retention is quick-connect but the 500-cycle rating means it is not intended for frequent field reconnections over the life of the equipment; it suits a semi-permanent panel feed-through or a test-point that sees occasional swaps. Bulkhead mounting: the adapter passes through the panel hole, the lockwasher goes on the inside face, and the nut tightens from the back. The nickel-plated brass body grounds to the panel through the lockwasher contact. No additional gasket or seal is provided — this is an indoor, dry-environment fit, not a weatherproof bulkhead pass-through.

MPN
228553-1