Poke-In Wire Receptacle, 2-Position, 4.00mm Pitch — No Crimp Required
It belongs to the 2834006 series of SMT right-angle connectors that accept solid or stranded wire directly — no crimp terminal needed. The 0.157" (4.00mm) pitch gives enough spacing for 400V rated creepage without forcing a wide board footprint. Housing is natural resin; contacts are tin-plated copper alloy.
5A or 6A — Which Current Rating Applies?
The higher value typically applies at the largest wire gauge (18 AWG) with lower temperature rise; the 5A figure is the conservative rating across the full 18-22 AWG range. For a 22 AWG build in a warm enclosure, plan on 5A per circuit. The 400V rating is generous for a 4.00mm pitch connector — this part handles line-voltage isolation in equipment where the poke-in feature saves assembly time.
This is a receptacle that accepts stripped wire directly — 18 AWG, 20 AWG, or 22 AWG solid or stranded. There is no separate crimp terminal; the wire pokes into the SMT contact beam and is retained by the housing latch. The mating half is a corresponding header or blade connector (not included with this part) that fits the 4.00mm pitch and 2-position layout.