M12 A-coded 8-position receptacle — sealed, shielded, screw-terminated
The T4113011081-000 is an M12 A-coded receptacle with 8 male pins, designed for industrial sensor and actuator networks where a dust-tight, waterproof connection is required. It carries an IP67 rating, meaning the mated pair withstands temporary immersion and dust ingress — suited for washdown zones, outdoor cabinets, and factory-floor harnesses. The shell is shielded nickel-plated brass, so the connector bleeds EMI to ground before it reaches the signal contacts. Rated 2 A per contact at 30 V, with gold-over-nickel plating at 3.00 µin (0.076 µm) on the mating surface. The 8-position count is higher than the common 4- or 5-pin M12, so confirm the mating half carries the same shell size and pin arrangement before ordering.
Wiring and termination — screw-clamp, right-angle exit
Termination is screw-clamp, accepting cable diameters from 0.157" to 0.236" (4.00 mm to 6.00 mm). The right-angle cable exit keeps the assembly low-profile against the panel or junction box — useful when the cable must run parallel to the mounting surface. The backshell is brass with nickel plating, matching the shell finish and providing continuous shielding coverage through the cable gland. The threaded fastening ring (M12 x 1.0) mates with any standard M12 A-coded plug. Torque to the manufacturer's spec — over-tightening can distort the O-ring seal and compromise the IP67 rating. The polyamide insert provides the thread lock and dielectric isolation between pins.