Skip to main content
Molex 0734153033

Molex 0734153033 SMP Jack, 50 Ohm, 40 GHz, RG-405

MPN 0734153033
Active

Molex SMP series jack, female socket, 50 Ohm impedance, DC to 40 GHz, for RG-405 (.086 semi-rigid) cable, gold body, snap-on coupling, solder shield termination, free-hanging right-angle mount, tray package.

$6.0400 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Aug 2026

Specifications

0734153033 key specifications
ParameterValue
MountingFree Hanging (In-Line), Right Angle
Connector typeJack, Female Socket
Fastening typeSnap-On
Voltage rating335 V
Frequency - max40 GHz
Cable groupRG-405 (.086 Semi Rigid)
Operating temperature-65°C ~ 155°C
Body materialBeryllium Copper
Housing colorGold
Dielectric materialPolytetrafluoroethylene (PTFE)
Center contact materialBeryllium Copper
PackageTray

All specifications

0734153033 additional specifications
ParameterValue
Impedance50 Ohms
Body finishGold
Mating cycles100
Insertion loss0.1dB
Number of ports1
Shield terminationSolder
Contact terminationSolder
Center contact platingGold

Product details

SMP Jack for RG-405 Semi-Rigid — 40 GHz, Blind-Mate Interface

The Molex 0734153033 is an SMP-series jack, female socket, designed for direct solder termination to RG-405 (.086 inch diameter) semi-rigid coaxial cable. The SMP interface is a blind-mate, push-on (snap-on) coupling that allows dense board-to-board or module-to-backplane RF interconnects without the thread engagement of an SMA. The dielectric is PTFE, chosen for low loss and stable phase over temperature. Shield termination is via solder to the outer conductor of the semi-rigid cable — no crimp tool needed, just a controlled soldering station and the correct prep dimensions for the RG-405 dielectric.

Cable Prep and Termination

This jack is built specifically for RG-405 (.086 inch) semi-rigid cable — the center conductor, dielectric, and outer conductor dimensions are matched to the connector's bore and pin geometry. The shield is soldered directly to the connector body; no ferrule or crimp sleeve is involved. The contact termination is also solder, meaning the center pin is soldered to the cable's center conductor after the dielectric is stripped to the correct length. The manufacturer's application note for the 073415 series gives the exact strip dimensions — critical to maintain the 50 Ohm impedance through the transition. Because the connector is a right-angle body, the cable exits at 90 degrees to the mating axis. This is the common orientation for board-edge or module-face mounting where the cable routes along the chassis wall. The free-hanging mount means there are no panel-mount threads or flange holes — the connector relies on the cable's own stiffness and the mating connector's retention to stay in place.

The base product number is 073415, and this specific variant is the right-angle, RG-405, snap-on SMP jack in a tray package.

MPN
0734153033