Skip to main content
Samtec Inc. SMA-J-P-H-ST-EM3

Samtec SMA-J-P-H-ST-EM3 SMA Jack, 50 Ohm, 20 GHz, SMT

MPN SMA-J-P-H-ST-EM3
Active

Samtec SMA-J-P-H-ST-EM3, SMA jack female socket, 1 port, 50 Ohms impedance, DC to 20 GHz, gold-plated brass body, PTFE dielectric, board-edge SMT mount, threaded coupling, -65°C to 125°C.

$6.1300 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Jul 2026

Specifications

SMA-J-P-H-ST-EM3 specifications
ParameterValue
MountingBoard Edge, Cutout; Surface Mount
Connector typeJack, Female Socket
Fastening typeThreaded
Voltage rating335 V
Frequency - max20 GHz
Operating temperature-65°C ~ 125°C
Body materialBrass
Housing colorGold
Dielectric materialPolytetrafluoroethylene (PTFE)
Center contact materialCopper Alloy
PackageTray
Impedance50 Ohms
Body finishGold
Number of ports1
Shield terminationSolder
Contact terminationSolder
Center contact platingGold

Product details

RF Interconnect for Board-Edge Launch

The Samtec SMA-J-P-H-ST-EM3 is a 50 Ohm SMA jack (female socket) rated DC to 20 GHz, built for board-edge SMT mounting. The gold-plated brass body and PTFE dielectric keep the impedance clean through the transition from the PCB trace to the coaxial cable. The threaded coupling nut mates with standard SMA male plugs and holds the pair tight under vibration — no snap-on or push-pull here, just a full 1/4-36 thread engagement.

What the 20 GHz Ceiling Means for Your Signal Path

20 GHz is the upper end of the rated frequency band — the connector's VSWR and insertion loss are specified to stay within SMA interface limits across that span. For a 5 GHz application, you have nearly four octaves of margin; the connector is electrically transparent at those frequencies. The practical limit is the launch geometry on your PCB — keep the trace width and ground-plane clearance matched to 50 Ohm to avoid a reflection at the solder joint.

Mounting and Termination — Board-Edge SMT Fit

This jack mounts at the board edge with surface-mount pads — the shield tabs and center contact all terminate to solder pads on the same side. No through-holes, no backside soldering. The cutout in the board edge lets the connector body sit flush with the PCB profile, which keeps the RF ground plane continuous under the interface.

Active lifecycle — the connector is supplied in tray packaging.

MPN
SMA-J-P-H-ST-EM3