The Amphenol ICC 92634-152HLF is a 52-position dual-row BERGSTIK II board-to-board header — a standard 0.100 inch (2.54 mm) pitch male pin header designed for through-hole right-angle mounting on a PCB. With a 5 A per circuit current rating and 30 µin gold-over-nickel contact plating on the mating interface, it handles signal and low-power interconnects across two rows of square-pin contacts in an unshrouded push-pull body. The 0.190 inch (4.83 mm) insulation height sets the board standoff when seated, and the 0.318 inch (8.08 mm) post length gives adequate solder fill in through-hole termination. Contact material is phosphor bronze; all 52 positions are fully loaded. The housing is UL94 V-0 rated black thermoplastic.
Board layout engineers recognize the 0.100 inch pitch as the most common grid in legacy and industrial control interconnect — it mates with matching dual-row receptacles and IDCheaders in the BERGSTIK II series, and the through-hole footprint tolerates wave or hand-solder assembly. The right-angle orientation places the mating face perpendicular to the PCB plane, so the z-height budget above the board surface is the insulation height plus the mated connector depth. The 110 V rating is the voltage ceiling for the connector assembly; the 5 A per circuit rating governs wire gauge and signal path planning on the board. The 30 µin gold contact finish is the key durability spec — at this thickness it supports repeated mating cycles better than thin flash gold, so the push-pull fastening type is adequate for applications with occasional field replacement or service reconnect cycles.
The 92634-152HLF is Active in production. Quoted to order against BOM quantity with no official LTB or NRND flag. The BERGSTIK II series carries a broad position-count ladder, which means alternative counts in the same family are available if the board design allows a position-count change — confirm with the layout before committing.