Mixed signal-power header for wire-to-board
The 10162688-207206CLF: This is a 13-position SMT header from the ComboLock series, wired as 7 signal circuits plus 6 power contacts — not a standard 13-pin layout. The male blade contacts are rectangular, gold-plated at 5.00 µinch over copper alloy — that's a signal-grade finish, not a high-cycle power contact, so treat the power pins as current-limited to what the gold flash and 1.00 mm pitch can handle. The latch holder is the primary retention; the SMT solder tails rely on the board pads for shear strength, so a secondary strain relief on the cable side is worth planning for if the harness sees frequent flex.
Where this sits in the ComboLock series
The ComboLock series is built around mixed signal-power configurations at 1.00 mm pitch. This 13-position version (7+6) sits between the smaller 10-position (6+4) and larger 16-position (8+8) siblings — the 7+6 split is specific enough that a direct pin-compatible alternative is unlikely without a board layout change.