SMA Receptacle, 50 Ohm, 18 GHz — Bulkhead Kit with Hardware
The 132416: It's a threaded, front-side nut bulkhead mount — the kind of connector you see on test equipment panels, antenna feeds, and RF enclosures where the signal path needs a clean launch through the chassis wall. The dielectric is PTFE, the standard for RF connectors that need stable impedance up through Ku-band frequencies.
The 18 GHz max frequency and 50 Ohm impedance together tell you this connector is specced for the full Ku-band — satellite uplinks, point-to-point radios, and test instrumentation that sweeps past 12 GHz. The 500 mating cycles mean the gold-on-beryllium-copper contact will hold its insertion loss spec through field-service reconnects, not just a one-time install. The PTFE dielectric holds its dielectric constant across that range, so the impedance doesn't drift with temperature.
Mounting and Termination — Board Edge or Panel, Solder Your Shield
This connector gives you two mounting paths: board edge / end launch for a PCB, or panel mount through a bulkhead with the included front-side nut. The shield termination is solder — you tin the braid or the PCB ground plane and flow solder to the body. The center contact also terminates by solder, so you're working with a soldering iron, not a crimp tool. For a bulkhead install, the lockwasher goes between the nut and the panel face to prevent the connector from spinning loose under cable torque.
The 132203 is the closest functional sibling — same brass body, gold plating, 50 Ohm impedance, 500-cycle rating, and the same three-piece kit with lockwasher and nut. The difference is the frequency ceiling: the 132203 is rated to 12.4 GHz, while the 132416 goes to 18 GHz. If your system only needs X-band or below, the 132203 is a cost-effective drop-in. If you're working up through Ku-band, the 132416 is the one that stays within spec.
