Skip to main content
Amphenol 132416

Amphenol 132416 SMA Receptacle, 50 Ohm, 18 GHz

MPN 132416
Active

Amphenol SMA receptacle, 50 Ohm, 18 GHz, 1 port, bulkhead front-side nut mount, solder termination, gold-plated brass body, includes lockwasher and nut.

$11.9000 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Aug 2026

Specifications

132416 key specifications
ParameterValue
MountingBoard Edge, End Launch; Panel Mount
Connector typeReceptacle, Female Socket
Fastening typeThreaded
Frequency - max18 GHz
Mounting featureBulkhead - Front Side Nut
Operating temperature-65°C ~ 165°C
Body materialBrass
Housing colorGold
Dielectric materialPolytetrafluoroethylene (PTFE)
Center contact materialBeryllium Copper
Includes3 pcs - 1 Connector, 1 Lockwasher, 1 Nut
Impedance50 Ohms

All specifications

132416 additional specifications
ParameterValue
PackageBag
Body finishGold
Mating cycles500
Number of ports1
Shield terminationSolder
Contact terminationSolder
Center contact platingGold

Product details

SMA Receptacle, 50 Ohm, 18 GHz — Bulkhead Kit with Hardware

The 132416: It's a threaded, front-side nut bulkhead mount — the kind of connector you see on test equipment panels, antenna feeds, and RF enclosures where the signal path needs a clean launch through the chassis wall. The dielectric is PTFE, the standard for RF connectors that need stable impedance up through Ku-band frequencies.

The 18 GHz max frequency and 50 Ohm impedance together tell you this connector is specced for the full Ku-band — satellite uplinks, point-to-point radios, and test instrumentation that sweeps past 12 GHz. The 500 mating cycles mean the gold-on-beryllium-copper contact will hold its insertion loss spec through field-service reconnects, not just a one-time install. The PTFE dielectric holds its dielectric constant across that range, so the impedance doesn't drift with temperature.

Mounting and Termination — Board Edge or Panel, Solder Your Shield

This connector gives you two mounting paths: board edge / end launch for a PCB, or panel mount through a bulkhead with the included front-side nut. The shield termination is solder — you tin the braid or the PCB ground plane and flow solder to the body. The center contact also terminates by solder, so you're working with a soldering iron, not a crimp tool. For a bulkhead install, the lockwasher goes between the nut and the panel face to prevent the connector from spinning loose under cable torque.

The 132203 is the closest functional sibling — same brass body, gold plating, 50 Ohm impedance, 500-cycle rating, and the same three-piece kit with lockwasher and nut. The difference is the frequency ceiling: the 132203 is rated to 12.4 GHz, while the 132416 goes to 18 GHz. If your system only needs X-band or below, the 132203 is a cost-effective drop-in. If you're working up through Ku-band, the 132416 is the one that stays within spec.

MPN
132416