BERGSTIK 55101-G1109LF — 9-Pin Unshrouded Header for Board-to-Board Duty
It uses the standard 0.100" (2.54 mm) pitch, which matches legacy DIP footprints and 0.1" grid prototyping boards without a custom layout.
If your load pulls more than 5 A through any single pin, you need a larger-gauge contact or a higher-current series. The 110 V voltage rating is the working limit between adjacent pins; the unshrouded design means creepage distance is just the air gap between pins, so keep the voltage below that ceiling.
The 0.090" (2.29 mm) solder tail length is designed for through-hole soldering on a standard 0.062" (1.6 mm) thick PCB. Termination is solder-only — no press-fit or IDC option on this variant. The through-hole tails are tin-plated for good wetting with lead-free SAC solder profiles.
No official cross-reference or direct equivalent is listed for this order code. If you need a pin-compatible alternative within the BERGSTIK family, the selection parameters are: 0.100" pitch, single row, 9 positions, right-angle through-hole, unshrouded, gold mating finish. Any header matching those five constraints will fit the same board footprint and mate with the same receptacle.