32 Circuits at 2.54mm Pitch — BOM Fit Check
The 68021-132HLF: The 0.120" (3.05mm) solder tail length is standard for through-hole soldering on a typical 1.6mm board.
Right-Angle Through-Hole — Board Layout Notes
Push-pull fastening type: the header has no locking latch. In a vibration environment, the mating connector's own friction or an external wire-tie should be used to prevent back-out. The phosphor bronze contacts handle the thermal cycling without stress relaxation at the solder joint.
Active Production — Sourcing This Part
Sourced through independent distribution channels. The standard package is a bag, not tape-and-reel, consistent with through-hole headers.
Comparing to the 16-Position Sibling
Same 2.54mm pitch, same 30µinch gold plating, same right-angle through-hole footprint. If your BOM calls for 16 circuits, the 68021-116HLF is a drop-in replacement on a shorter header — no board layout change beyond the pin count.