The Amphenol 68023-407HLF is a 7-position, single-row, unshrouded male pin header from the BERGSTIK® II series. It uses the classic 0.100" (2.54 mm) pitch — the same grid as standard DIP packages and perf-board — so it drops into a legacy footprint without a layout change. The right-angle through-hole termination orients the pins parallel to the PCB, which suits board-edge or low-profile mezzanine connections where vertical space is tight.
Rated 5 A per contact at 110 V, with tin-on-tin plating (100.0 µin on the mating side). Tin is fine for a few dozen mating cycles in a clean indoor environment — it cold-welds on first mate and the oxide layer breaks through with a wipe. For higher cycle counts or corrosive atmospheres, step up to a gold-plated sibling in the same series. The housing is rated UL94 V-0, so it meets the flame-retardant requirement for equipment inside an enclosure. The 0.305" (7.75 mm) post length gives enough tail for a standard 1.6 mm PCB with a through-hole solder joint that won't wick up into the insulator.
Sourcing & Lifecycle
The 68023-407HLF carries an Active lifecycle status from Amphenol — no end-of-life notice, no last-time-buy clock.