The Amphenol BERGSTIK® II 68023-430HLF is a 30-position, single-row unshrouded male pin header on the standard 0.100" (2.54 mm) pitch. It is a through-hole, right-angle part — the pins exit parallel to the board, suiting it for board-edge I/O, mezzanine stacking with a 90° cable exit, or connecting a riser card where z-height is tight. The header carries tin-plated phosphor bronze contacts rated 5 A per circuit at 110 V, with a 100.0 µin (2.54 µm) tin mating finish.
The 0.100" (2.54 mm) pitch is the breadboard standard — this header drops into a perfboard or mates with any 0.100" pitch IDC or crimp receptacle without a layout change. The 30-position single-row format gives a narrow board footprint: one row of holes, one pass of the soldering iron. The 5 A per-circuit rating with tin plating means signal-level or moderate power duty — think GPIO headers, programming ports, or low-current board interconnects. Tin is fine for a handful of mating cycles (50–100), but if this connector sees repeated field service, the tin contact finish will wear faster than gold.
No official cross-reference or successor is on record for this order code. The UL94 V-0 rating and tin plating are standard for commercial equipment inside an enclosure.