The Amphenol 68023-433HLF is a 33-position, single-row, unshrouded male pin header from the BERGSTIK® II series. It is a board-to-board interconnect — the unshrouded design means the pins are exposed, intended to mate with a standard 0.100" pitch female socket strip. The right-angle through-hole termination routes the header parallel to the PCB surface, which is the typical orientation for board-edge cabling or mezzanine stacking where the cable exits along the board plane. Tin plating on both the mating surface and the solder tail keeps the cost down for signal-duty applications where the connector mates infrequently.
Key Specs and What They Mean for Fit
The 0.100" (2.54 mm) pitch matches the standard DIP footprint. 33 positions is an odd count for a single-row header; most BergStik headers come in even counts. The 5 A per-contact rating with tin plating is typical for signal-level interconnect. The 110 V voltage rating is the working limit between adjacent pins. The right-angle through-hole mounting gives a mated stack height of roughly 0.136" (3.45 mm) above the PCB — the mating contact length — plus the height of the mating socket. The 0.305" (7.75 mm) post length gives enough tail for a standard board with a wave-solder fillet. The UL94 V-0 housing is the standard flame rating for equipment inside an enclosure.
Sourcing and Lifecycle
The 68023-433HLF carries an Active lifecycle status from Amphenol — full production, no end-of-life notice or last-time-buy window. No official cross-reference or direct replacement is on record — the BOM line is the part itself.