Product Introduction
The FCI BERGSTIK® II 68657-136HLF is a 36-position, single-row, unshrouded male pin header on a standard 0.100" (2.54mm) pitch. The 0.100" pitch matches legacy perf-board and breadboard layouts, and the 36 positions give you a full bank of signal or low-power lines in one connector.
The 0.100" (2.54mm) pitch is the classic DIP/IC footprint pitch — it fits standard 0.100" grid prototyping boards and mates with any 0.100" pitch female socket strip. The 110V voltage rating is fine for logic-level and low-voltage DC rails, but not for mains or high-voltage bus work.
Through-hole solder termination. The pins are square male pins, 0.025" square typical for this series, with a 0.368" (9.35mm) post length below the insulator — enough to clear a standard 0.062" PCB and still leave room for a solder fillet. The 0.120" (3.05mm) mating pin length engages fully with a standard 0.100" pitch female socket.