BERGSTIK II 34-Position Right-Angle Header
The Amphenol ICC 68695-134HLF is a 34-position, dual-row, unshrouded male pin header from the BERGSTIK II series. It uses the standard 0.100" (2.54 mm) pitch on both rows and between rows, making it a direct fit for legacy DIP-grid layouts or universal perforated boards. Rated 5 A per circuit with a 110 V voltage rating, it handles typical board-to-board signal and low-power interconnect duties. The right-angle through-hole termination places the header parallel to the board edge, useful for mezzanine or edge-card connections where vertical clearance is tight.
Contact Plating and Mating Cycles
The mating surface carries 30.0 µ" (0.76 µm) of gold or gold GXT™ over phosphor bronze base metal. That gold thickness supports hundreds of mating cycles without contact fretting or resistance drift — a practical choice for test headers, programming jigs, or any interconnect that sees repeated engagement. The unshrouded push-pull fastening means no latch to wear out, but the pins are exposed and require care during handling to avoid bending.
Board Layout and Mechanical Fit
The 0.100" pitch and 0.100" row spacing map to a standard 0.100" x 0.100" grid. The mating pin length is 0.230" (5.84 mm), and the solder post is 0.090" (2.29 mm) long.
Lifecycle and Sourcing
The 68695-134HLF carries an Active lifecycle status — no end-of-life notice or last-time-buy window on record. No official cross-reference or direct replacement is listed, so the BOM line should match this exact order code for the 34-position, dual-row, right-angle configuration.