Board footprint and stack height for the 69146-204LF
The 0.200" (5.08 mm) height above the board leaves room under a low-profile enclosure or mezzanine card, but the open-top design means the jumper sits flush on the header pins without a shroud adding extra z-height. Rated 2 A per contact — the limiting factor here is the contact beam cross-section and the 30.0 µinch gold or GXT™ plating, not the housing. At 2 A the temperature rise stays within the UL94 V-0 polyester limit, so this jumper handles signal-level shunting on configuration headers, address selection, and enable lines without derating.